⚠️Clean with plate removed from machine - do NOT spray cleaner inside machines! ⚠️Ensure plate is COOL - do NOT apply when HOT! ⚠️Make sure Z-Offset is properly calibrated!
50/50 Isopropyl Alcohol/Water solution
Spray bottle
Microfiber or dust-free towels
Prepare cleaning solution : Mix 50/50 Isopropyl Alcohol/H₂O solution in a spray bottleApply solution : Spray onto build plate with microfiber or dust-free towelLet soak : Allow solution to sit for 10 secondsWipe clean : Remove solution completelyRepeat process : Apply solution again and wipe with new towel or clean sideVisual inspection : Verify plate is completely clean before proceeding
⚠️Ensure Plate is COOL, do NOT apply when HOT! ⚠️Make sure Z-Offset is Optimal
Shake the dauber bottle well THEN remove lid
For first use, prime the tip by pressing down until tip is soaked
Push tip firmly against the buildplate with a light squeeze while moving around the print area
Distribute HYPERLOK® in a hatch/grid pattern until evenly applied
Let dry for ~3 minutes before heating the bed
Relax! Your parts will be HYPERLOK'd to your surface
Let your parts cool fully in the build chamber before removing for bed temperatures 100°C or less
Let your parts cool partially in the build chamber and remove while warm for bed temperatures 120°C or more
Clean fully between coats, layering coats will NOT increase adhesion, each surface will last multiple prints
If you experience adhesion problems, try these adjustments:
Lower Z-Offset by -0.02mm increments Increase bed temperature by 10°C increments Increase first layer temperature by 5°C increments For Warpy PLA Parts its advised to LOWER the Z-Offset by -0.03 to ensure a good "squish"
For bed temperatures 100°C or less:
Let parts cool fully in the build chamber before removing
For bed temperatures 120°C or more:
Let parts cool partially in the build chamber and remove while warm
If parts are sticking too well, raise Z-Offset in +0.02 Increments For ABS/ASA its advised to RAISE the Z-Offset (Start with +0.03) to avoid over-adhesion
¶ Maintenance Tips
Clean fully between coats - layering coats will NOT increase adhesion
Each surface application will last multiple prints
Purchase new Dauber when fluid level reaches the "Refill soon" marking on side gaugeBUY New Dauber HERE!
Your browser does not support the video tag.
Your browser does not support the video tag.
We value your feedback! Please share your experience:
KPD HYPERLOK® - Your Reliable Solution for 3D Print Bed Adhesion.