This guide provides step-by-step instructions for refilling your HYPERLOK® 40ml applicator using the 240ml pump bottle refill system.
Refill the applicator when the fluid level reaches the "Refill soon" marking on the side gauge.
- Check fluid level: Confirm the applicator has reached the "Refill soon" marking on side gauge
- Shake pump bottle: Shake the 240ml pump bottle well before refilling
- Prepare tip (if using new tip): For first use of a new tip, see HYPERLOK 40ml Refillable Applicator Instructions
- Position applicator: Center the pump tip inside the 40ml applicator opening
- Begin pumping: Use firm, steady pumps to transfer fluid
- Monitor fill level: Depending on pump pressure, 18-20 pumps will refill the applicator completely
- Verify fill: Check that applicator is properly filled to operational level
- Resume printing: Your applicator is now ready for continued use
¶ Tips and Notes
- The wide tip will require about 1/4 of the bottle volume when first primed
- New replacement tips are available for purchase
- Apply HYPERLOK® by pushing tip firmly against buildplate with light pumping action while moving around print area
We value your feedback! Please share your experience:
KPD HYPERLOK® - Your Reliable Solution for 3D Print Bed Adhesion.